Turntable forward and reverse rotation: the table can turn in two directions of operation.

Angles selector: desired angle is obtained by inserting the pin in the bending table periphery.

Two drive systems: automatic, and continuous for spirals. Remote control by pedal.

Electric board: in monoblock, sealed case –low voltage (48 v) – with emergency stop as per CEE Standards.

Reduce lubrication by oil bath: there is no hand oiling point. Fitted with brake-motor.

Swing square: with complete equipment of bending bushes and bolts. Special attachments: stirrups, spirals, etc.

Turn table of big diameter: 375 mm (D-36L & D-42L) / 445 mm (D-52L)-with 9 bending holes-whith possibility to change point “0”. (D-36L, D-42L & D-52L).

Gathering tray: at the bottom, to keep pedal, bolts, bushes, tools, etc. Bending guard safety system that prevents the Access to the bending are during the turning of the plate.

Bending Guard: safety system that prevents the acces to the bending area during the turning of the plate.

ROUND STEEL ( yield strength )	TENSILE STRENGTH		D-36L			D-42L			D-52L
			1	2	3	1	2	3	1	2	3
250 N/mm²	450 N/ mm² – 65.000 P.S.I.		36	28	24	42	33	29	52	40	28
400 N/ mm²	650 N/ mm² – 90.000 P.S.I.		32	25	22	37	28	24	45	35	28
500 N/ mm²	850 N/ mm² – 120.000 P.S.I.		29	23	20	34	27	23	40	35	28
Turntable speed		r.p.m..	7,8			6,6			6,25
Engine power		K.W.	3			3			5,5
Dimensions and Net weight		Kg	275			280			492
		mm	950 x 600 x 933			950 x 600 x 976			1000 x 684 x 976